| Step | | Procedure & Parts & Tools |
| 1 |
|
Drop the deck.
|
| 2 |
|
Locate the switch by looking though the square hole in the right side of the frame. Switch should be free to move up and down.
|
| 3 |
|
View from underneath. Switches stuck in the up position will prevent the brushes from turning.
|
| 4 |
|
Open tank and locate the wires coming out of the end of the switch. Note the orientation of the wires and the location of the plug-in at the Power Board. If the wires are disconnected...the brushes will spin, even when the deck is raised.
|
| 5 |
|
Unplug the wires from the Power Board. Using a flathead screwdriver pry the switch out from the frame.
| Screwdriver-flat tip |
|
|
| 5 |
|
Pull the switch and wires out as a unit. Transfer wires to new switch. Feed wires back up through frame, new switch will snap in place.
|